Difference between revisions of "Dev:cc3200"
(→Notes for Linux) |
|||
| Line 1: | Line 1: | ||
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware. |
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware. |
||
= Code Composer studio on Linux = |
|||
* [http://processors.wiki.ti.com/index.php/Linux_Host_Support_CCSv6 TI CCS v6 wiki] |
|||
= Notes for Linux = |
= Notes for Linux = |
||
== Serial connection == |
== Serial connection == |
||
| Line 17: | Line 25: | ||
sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi |
sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi |
||
sudo apt-get install openocd |
sudo apt-get install openocd |
||
= Resources = |
= Resources = |
||
Revision as of 17:47, 10 December 2014
TI Chip with Arm Cortex M4 and network processor with ipV4 in hardware.
Contents
Code Composer studio on Linux
Notes for Linux
Serial connection
Enable recognition for the serial USB connection, which is a FTDI chip with TI codes:
sudo su modprobe ftdi-sio echo 0451 c32a > /sys/bus/usb-serial/drivers/ftdi_sio/new_id
Alternative: use this udev rule:
ATTRS{idVendor}=="0451", ATTRS{idProduct}=="c32a", MODE="0660", GROUP="dialout", RUN+="/sbin/modprobe ftdi-sio", RUN+="/bin/sh -c '/bin/echo 0451 c32a > /sys/bus/usb-serial/drivers/ftdi_sio/new_id'"
Tools
Install arm tools. May have to remove gdb first.
sudo apt-get remove gdb sudo apt-get install binutils-arm-none-eabi gdb-arm-none-eabi gcc-arm-none-eabi libnewlib-arm-none-eabi sudo apt-get install openocd
